Yes, if you have a drive encrypted with LUKS (Linux Unified Key Setup) and you know the password, you can decrypt and mount it easily. Here's how to do it step-by-step: 1. Identify the drive First, identify the device where your LUKS-encrypted partition is located. You can do this using the lsblk or fdisk command: bash lsblk or bash sudo fdisk -l This will list the block devices, and you should see your encrypted partition listed, often something like /dev/sdX (where X is a letter corresponding to your drive). LUKS partitions are typically marked as crypt. 2. Open the LUKS-encrypted drive Once you've identified the correct partition, use the following command to open (decrypt) it with cryptsetup: bash sudo cryptsetup luksOpen /dev/sdX my_encrypted_drive Here, replace /dev/sdX with your actual partition path. The my_encrypted_drive part is an arbitrary name for the decrypted volume that you will use later. You'll be prompted for the password you set up when encrypting the drive. 3. Mount the decrypted partition After decrypting the drive, you need to mount the decrypted partition. First, check which new device has been created using lsblk or ls /dev/mapper: bash ls /dev/mapper You should see something like /dev/mapper/my_encrypted_drive. Now, mount it to a folder, say /mnt/mydrive: bash sudo mount /dev/mapper/my_encrypted_drive /mnt/mydrive 4. Access the drive Now, you can access the files on your LUKS-encrypted drive under /mnt/mydrive. 5. Unmount and close the LUKS device Once you're done with the drive, you should unmount and close it properly. Unmount the partition: bash sudo umount /mnt/mydrive Close the LUKS-encrypted device: bash sudo cryptsetup luksClose my_encrypted_drive Optional: Check LUKS header You can also verify that the partition is LUKS-encrypted before proceeding, using this command: bash sudo cryptsetup luksDump /dev/sdX This ensures you're dealing with a LUKS partition. Let me know if you encounter any issues!